Diffstat (limited to 'Documentation/init.txt')
1 files changed, 49 insertions, 0 deletions
diff --git a/Documentation/init.txt b/Documentation/init.txt
new file mode 100644
@@ -0,0 +1,49 @@
+Explaining the dreaded "No init found." boot hang message
+OK, so you've got this pretty unintuitive message (currently located
+in init/main.c) and are wondering what the H*** went wrong.
+Some high-level reasons for failure (listed roughly in order of execution)
+to load the init binary are:
+A) Unable to mount root FS
+B) init binary doesn't exist on rootfs
+C) broken console device
+D) binary exists but dependencies not available
+E) binary cannot be loaded
+0) Set "debug" kernel parameter (in bootloader config file or CONFIG_CMDLINE)
+ to get more detailed kernel messages.
+A) make sure you have the correct root FS type
+ (and root= kernel parameter points to the correct partition),
+ required drivers such as storage hardware (such as SCSI or USB!)
+ and filesystem (ext3, jffs2 etc.) are builtin (alternatively as modules,
+ to be pre-loaded by an initrd)
+C) Possibly a conflict in console= setup --> initial console unavailable.
+ E.g. some serial consoles are unreliable due to serial IRQ issues (e.g.
+ missing interrupt-based configuration).
+ Try using a different console= device or e.g. netconsole= .
+D) e.g. required library dependencies of the init binary such as
+ /lib/ld-linux.so.2 missing or broken. Use readelf -d <INIT>|grep NEEDED
+ to find out which libraries are required.
+E) make sure the binary's architecture matches your hardware.
+ E.g. i386 vs. x86_64 mismatch, or trying to load x86 on ARM hardware.
+ In case you tried loading a non-binary file here (shell script?),
+ you should make sure that the script specifies an interpreter in its shebang
+ header line (#!/...) that is fully working (including its library
+ dependencies). And before tackling scripts, better first test a simple
+ non-script binary such as /bin/sh and confirm its successful execution.
+ To find out more, add code to init/main.c to display kernel_execve()s
+ return values.
+Please extend this explanation whenever you find new failure causes
+(after all loading the init binary is a CRITICAL and hard transition step
+which needs to be made as painless as possible), then submit patch to LKML.
+- Implement the various run_init_process() invocations via a struct array
+ which can then store the kernel_execve() result value and on failure
+ log it all by iterating over _all_ results (very important usability fix).
+- try to make the implementation itself more helpful in general,
+ e.g. by providing additional error messages at affected places.
+Andreas Mohr <andi at lisas period de>